My Cricut Circle Bracelet

Here is a photo of my Circle Bracelet. We received the charm bracelet with the green charm for joining the Circle. When you attend a meet-up you are given a blue charm. I have been to three meet-ups so far, and I had received three blue charms so I altered them to say the location of the meet-up and the year, so I will always remember where each charm was from.

I used ink jet transparency paper, and Diamond Glaze dimensional Adhesive.

I printed the State/date on the transparency film. Then I cut it to fit the back side of the charm. I glued it on with the Diamond Glaze. After the back dried, then I put a coat of Diamond Glaze on the front to seal in the ink jet printing.

The white charms were buttons I received from the first meet-up at CHA. I used my Fiskars craft drill to drill the holes in them after I removed the pin shank. Then I attached them to the bracelet using jump rings.